Download USER MANUAL // OPEN
Transcript
Quick Nav Table of Contents Introduction I/O Module Panel Layouts Snare and Tom Trigger Zones NFUZD USB Key (Drive) and Data Management NSPIRE Series I/O Module Navigation Trigger Settings Hi-Hat (HH) Trigger Settings Kit Menu Reverb EQ Mixer Menu Saving a UserKit Adjusting the MIDI Map Trigger Function Settings Click Menu SEQ Menu Integration with Computer Setup Suggestions Sync Key Auto Off and Sleep Mode BFD Eco NFUZD Edition NSPIRE Series I/O Module Settings Getting Started w/ BFD Eco NFUZD Edition Basic Mixing Adjustments BFD Eco NFUZD Edition Effects Grooves Page Options Menu Help Menu Changing BFD Eco NFUZD Edition Presets Changing Drum Sounds Adjusting Instrument Parameters FX Slots Instrument and Mixer Faders Getting New Professional Sounds User .wav Samples Exporting Sound Banks Loops Installing Sound Banks BFD Eco Jukebox Player BFD Eco Master Output Recording BFD Eco Mixing Tips Included Sounds Basic Mixing Adjustments (cont.) Filter Mod This is a DCAM circuit-modelled multimode resonant filter with modulation and drive. As well as the Pitch (cutoff frequency) and Res (resonance) controls, the filter features a Mode control to switch between low-pass, band-pass, high-pass, peak and notch modes. There is even an audio-rate FMDepth control which sets the amount of cutoff modulation derived from the input signal’s waveform. The Drive function features controls for input (Drive) and output (OutDrive) drive stages. The effect contains a built-in envelope follower for modulating the cutoff frequency with the amplitude of the input signal. It features controls for Attack, Release, and Env Depth. Drive! Drive is a versatile, DCAM-modelled overdrive/distortion effect. The HPFreq and LPFreq controls allow you to filter the signal before the distortion stage, while the Mode control switches between four different distortion models: Diode, OTA, OpAmp and HalfRect. The Dirty control sets the amount of the distorted signal that is heard at the output, while the Clean control sets the amount of the signal that is filtered out before the bitcrushing stage by the high-pass and low-pass filters. The Tone control is a simple 1-pole low-pass filter to remove unwanted high frequencies from the Dirty signal. 47