Download Instruction Manual

Transcript
10.
Operation within range of bell-shaped head/capacity curve
In the case of a pump which generates a bell-shaped capacity curve in a low-flow range,
do not operate the pump in the section where the line ascends. (Refer to the standard
performance curve to verify the head/capacity). If the rightward ascending section of the
head/capacity curve is part of the pump operation specifications, design the piping by
observing the following points:
1.
The discharge piping should have no water tank or air trap,
2.
The discharge quantity must be adjusted by a valve which is installed
close to the discharge port of the pump.
8