Download Microstructure Profiler MSS90

Manufacturer:.........................ISW
Type:.......................................PNS01
Time constant:........................4 msec
Power supply:.........................+5 volt, -5 volt
Current consumption:.............<1 mA
Gain:..................................….11
Filter:.................................…..High pass 20dB/decade
Low frequency cutoff :.........…1 Hz (-3dB)
Connector:……………………..Lemosa PSA.1S.306.ZLL
2
3
1
6
4
5
Pin
Socket
Pin
Signal
colour
1
2
3
4
5
6
+5volt
Analog out
- 5volt
n. c.
GND
n. c.
red
green
blue
black
4.3. Acceleration sensor
To determine the level of vibration during the profiling process, the MSS
probe is equipped with a highly sensitive vibration control sensor. The
vibration control sensor measures the horizontal acceleration of the
profiler in one direction using a piezoceramic element. Horizontal
acceleration of the profiler generates a lifting force at a cantilever
construction inside the ACC-sensor. The lifting force and thus the output
of the sensor is proportional to the acceleration. Due to the lack of space
on the bottom end cap the ACC-sensor is mounted inside the probe.
The housing of the ACC-sensor has a length of 70mm and a diameter of