1
Download Instructional User Guide
Transcript
Chapter 3 – Feature Measurement Notes: Two planes were measured, one representing the lower base and one on top of the gage block, The lower base plane was used to establish the XY PCS Base Plane for both PCS 1 and 2. The top plane had an AZ/X of 89.9943° and the AY/Z was 90.0000°. The intersection with the pierce point with the PCS1 Z-Axis, d1, is reported at 1.9999". The reported pierce point on the Z-axis of PCS2, d2 is 1.9995". By not having PCS localized to the actual measured surfaces we introduced 0.0004", d3, error! Helmel Engineering Products, Inc. www.helmel.com Geomet Training Handbook www.geomet-cmm-software.com 3-9
