Download 3270 X/LT User`s Manual

XES COMMANDS
Page 14-13
value can be changed using XEDIT.
Units — 1/300"
s COMMAND: szf
s RANGE:
N/A
This command sets the unit of measurement for the purpose of setting page
size, margins and tabs to 1/300". The default value is 1/60", but it can be
changed using XTRAEDIT.
Margins
s COMMAND:
smH,T,B,L,Rd
s RANGE:
See chart
The “Margins” command is used to set page height and all margins,
where:
H is the vertical size of the paper, measured from the top edge to the
bottom edge of the physical page. In 1/60" units, 11.0" paper is 660. 8.5"
paper is 510.
T is the top margin, measured from the top edge of the page to the baseline
of the first line of text. In 1/60" units, a 2.0" margin is 120.
B is the bottom margin, measured from the bottom edge of the page to the
baseline of the last line of text on the page. In 1/60" units, 1.5" bottom
margin is 90.
L is the left margin, measured from the left edge of the page to the left
edge of the first character in each line on the page. In 1/60" units, a 1.75"
left margin is 105.
R is the right margin, measured from the left edge of the page to the right
edge of the last character in each line on the page. In 1/60" units, a 1.0"
right margin is 450 on a 8.5" portrait page.
The following chart shows maximum H,T,B,L,R values that will still print
on the physical page specified. Values are shown in both 1/60'' and 1/300''
for letter and tabloid paper in both portrait (P) and landscape (L)
orientations.