Download to read the D-Pro user manual

•
Click on the top-left of the Properties window to close it.
ADDING TRIGGERS
You can trigger any button or fader from a variety of controllers as follows:
•
Right-click on the button or fader. The Properties window appears.
•
Click on "Start trigger". The Trigger Properties window appears.
•
Click on the tab (Keyboard | MIDI | Enttec Wing) you want to use.
•
Select "Click to learn" and move/press the keyboard or control on the hardware.
•
Click OK to close Trigger Properties, then close Properties.
Now the button or fader will display the trigger above the label.
CHANGING FADE TIMES FOR BUTTONS & SLIDERS
You can modify the fade in & out time of each individual button & slider. This work for both cues &
cuelists:
•
Right-click on the button or fader. The Properties window appears.
•
Drag the "fade in" and "fade out" sliders to the desired value (or click and type a value in
seconds)
•
Click on the top-left of the Properties window to close it.
ADDING RADIO GROUPS
Sometimes you will want buttons to behave in a "radio box" manner - that is, only one button can
be active at any time. For example, you might have "Red", "Yellow" and "Green" cues, which
control the colour of your whole rig. You don't really want to MIX these cues, so the radio box is
the answer:
•
Right-click on the "Red" button. The Properties window appears.
•
Use the +/- buttons to set this to "Radio group : 1"
•
Close the Properties window
•
Repeat for the "Yellow" and "Green" buttons.
Now you will see all 3 buttons highlighted in a different colour (to indicate that they are a radio
group). When you switch on any button in the group, all others will switch off, with any fade in/out
times providing a nice smooth crossfade.
Page 35