Download User Manual

HANDLING THE REMOTE CONTROLLER
SET TEMPERATURE( C)
Swing operation
FAN
HIGH
MED
LOW
AUTO
COOL
DRY
HEAT
TEMP
ON/OFF FAN SPEED
MODE
SWING
1
Use the SWING button to adjust the Up/Down airflow direction.
1. When the button is quickly pressed once, the louver is adjusted by 6°.
Keep pressing the button to adjust louver to desired angle.
2. Press and hold for 2 seconds to activate/deactivate auto-swing function.
ECONOMY
RESET LOCK
TIMER ON
NOTE: When the louver swings to a position which would affect the cooling
(or heating) of the unit, it would automatically change the swing direction.
TIMER OFF
LED
DISPLAY
Timer operation
To set the Auto-on timer:
1. Press the TIMER ON button and remote will display TIMER ON. The last
auto-on setting and the signal “h” will also be displayed.
2. Press the TIMER ON button again to begin setting the desire time. Each
press of the button increases the time by 30-minutes, up to 10 hours.
Then by 1-hour increments, up to 24 hours.
SET TEMPERATURE( C)
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
TIMER ON
TEMP
To set the Auto-off timer:
1. Press the TIMER OFF button and remote will display TIMER OFF. The
last auto-off setting and the signal “h” will also be displayed.
2. Press the TIMER OFF button again to begin setting the desire time. Each
press of the button increases the time by 30-minutes, up to 10 hours.
Then by 1-hour increments, up to 24 hours.
ON/OFF FAN SPEED
MODE
SWING
ECONOMY TIMER ON
RESET LOCK
TIMER OFF
After setting TIMER ON/OFF, there will be a one-half second delay before
1 the remote controller transmits the signal to the AC unit. The after another
2 seconds (approximately), the “h” signal will disappear and set temperature
2 will re-appear on the display window.
LED
DISPLAY
NOTE: Timer ON/OFF is limited to the following time settings: 0.5, 1.0, 1.5,
2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10,
11, 12, 13, 14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24.
Examples of Timer setting
h
TIMER ON
Start
Off
Set
6 hours later
TIMER ON (auto-on operation)
The TIMER ON feature is useful when you want the unit to automatically
turn on, say before you return home from work.
Example:
To start the AC unit in 6 hours.
1. Press the TIMER ON button. Remote displays the last time setting and
the “h” signal.
2. Press the TIMER ON button repeatedly till “6:0h” is displayed on remote.
3. Wait for about 3 seconds and display will revert to show set temperature.
4. Auto-on function has been set.
20