Download manual

Connecting your TV
To cancel searching for the AP:
Press BACK while searching for the AP. A message will
appear and press v or w to select Yes and press OK.
Easy Setup using PIN (Personal Identification
Number)
1 From the Preferences menu, select Network
Setup and press OK.
2 Press s or r to select Wireless Setup, and press
OK.
3 Press s or r to select Easy Setup and press OK.
4 Press v or w to select PIN.
5 Press s to select Start Scan and press OK.
6 Press s or r to select the desired AP and press OK.
Note:
Check the Network Name and/or MAC address
on the label of the AP or in the manual and
select your AP.
7 When the PIN code window appears, enter the
displayed PIN into your AP and press Next to continue
the PIN Setup. When a message displays to report that
the setup is complete, press OK.
To cancel searching for the AP:
Press BACK while searching for the AP. A message will
appear and press v or w to select Yes and press OK.
Assisted Setup
1 From the Preferences menu, select Network
Setup and press OK.
2 Press s or r to select Wireless Setup and press
OK.
3 Press s or r to select Assisted Setup and press
OK.
4 Press s or r to select the desired AP and press OK.
Note:
Check the MAC address on the label of the AP
or in the manual and select your AP.
5 Select Security Key and press OK. The Software
Keyboard window will appear.
6 Input the Security Key by using the Software
Keyboard (- page 54). To save your setting, press
the BLUE button.
Notes:
• The Security Key must adhere to these
conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
• There is only one key ID to set for WEP encryption.
7 Select Done and press OK.
Note:
If Network Name is not displayed, see step 4
and 5 in Manual Setup below to set Network
Name before pressing Done.
Note:
Settings are not saved if BACK is pressed before
Done is selected.
Manual Setup
1 From the Preferences menu, select Network
Setup and press OK.
2 Press s or r to select Wireless Setup and press
OK.
3 Press s or r to select Manual Setup and press
OK.
4 Press s or r to select Network Name and press
OK. The Software Keyboard window will appear.
5 Input the Network Name by using the Software
Keyboard (- page 54). To save your setting, press
the BLUE button.
6 Press s or r to select Authentication and press v
or w to select Open System, Shared Key, WPAPSK or WPA2-PSK.
7 Press s or r to select Encryption and press v or w
to select None, WEP, TKIP or AES.
Notes:
•Certain encryption types are only compatible with
specific authentication types.
- When Authentication is Open System, only WEP
or None is compatible.
- When Authentication is Shared Key, only WEP is
compatible.
- When Authentication is WPA-PSK or WPA2-PSK,
only TKIP or AES is compatible.
•When incompatible Authentication/Encryption
pairings are detected, a warning message will be
displayed, and no connection attempt will be made
until the incompatibility is resolved.
•There is only one key ID to set for WEP encryption.
8 Press s or r to select Security Key and press OK.
9 Input the Security Key by using the Software
Keyboard (- page 54). To save your setting, press
the BLUE button.
Note:
This item is greyed out when Encryption is
None.
51
110809c1_324246SL800A_En.indb 51
11.8.9 9:05:03