Download User Manual - EndRun Technologies
Transcript
APPENDIX C Changing Channelset In the Praecis Ct, if the unit is locked when you enter the CHANNELSET command, then you also need to enter a REACQUIRE command in order to force the unit to start searching for a new CDMA signal. (See Chapter 3 - Control and Status Commands for details on CHANNELSET and REACQUIRE.) In the Praecis II, even if the unit is locked, it will automatically start searching for a new CDMA signal as soon as you enter the CHANNELSET command. Additional Fault Indicators Two new fault indicators have been added to the FLTSTAT command response. These are the Time Input Fault and the Main Osc Failure. See FLTSTAT in Chapter 3 - Control and Status Commands for details. Version Information In response to the VER command, the Praecis sends firmware and FPGA version information. This message is slightly different between the Praecis II and the Praecis Ct. See Chapter 3 - Control and Status Commands for a description of this command. Praecis II version information: Praecis II FW 6010-0063-000 v 1.00 FPGA 6020-0008-000 v 01<CR><LF> - Jun 25 2010 16:41:39 Praecis Ct version information: Praecis Ct FW 6010-0001-000 v 1.00 - Sep 18 2007 16:41:39 FPGA 6020-0001-000 v 01<CR><LF> Additional Commands The following commands are new and did not exist in the Praecis Ct: FLTMSG, PPSWIDTH, and command-specific HELP. See Chapter 3 - Control and Status Commands for more information on these new commands. Legacy Product Configurations The Praecis Ct and the Praecis Cf have been produced for many years. As such, over the years there has been developed equipment by other manufacturers intended to interface with these older products. In order to avoid disrupting this relationship, the Praecis II may be configured to mimic, as closely as possible, these older legacy products. 52 Praecis II User Manual