Download Livescribe Connect User Manual

Transcript
Selecting Pages on the Livescribe Smartpen
• Pencast PDF (notes and audio)
• M4A Audio (audio only)
Shortcuts specify the default send format in the Shortcuts tab of the Livescribe Connect computer app.
You can override the default format when selecting pages on the smartpen.
Sending Entire Audio Recording(s) with Note Selection
When you select notes, any recording associated with the notes is sent in its entirety.
IMPORTANT:
Even if you select a single page or part of page, each recording associated with any of the
selected notes is sent without being clipped. Consequently, a few brief notes that you send as Pencast
PDF may include a long audio recording or even multiple recordings.
Stop and Start Recording at Key Points
An audio recording is bounded by your tapping the Record button and later the Stop button. For
instance, consider a lengthy meeting. If you stop and re-start recording on your smartpen, you will end
up with two separate recordings.
TIP: One strategy to break a longer meeting, class, or interview into separate chunks is to stop the
recording and then start a new one at key points, notating the fact in your notebook. Be careful to enter
your notes in order and not go back to earlier notes while audio recording is on. If you observe that rule,
each section of your notes will contain only one recording. However, if you go back to an earlier section
while recording (or while listening to a recording after the meeting), that section will contain both the old
and newer recordings.
Preview Recordings in Livescribe Desktop
You can preview your audio recordings in Livescribe Desktop. Connect (dock) your smartpen to your
computer. Then try sending from Livescribe Desktop. In the More Options section of the Sending
Notes... dialog, you can play a recording and use the timeline controls to verify what you are about to
send.
44
Livescribe Connect User Guide