Download Operation Manual CLI

MAC
Operation Manual CLI
Command
Mode
Function
macmode VLANID MODE
Bridge
Defines a behavior per VLAN, based on configurations defined
by the previous prioprofilemap command.
Modifies the MAC mode value of specified VLAN.
VLANID: enter the VLAN-ID
MODE: number of MAC mode to be new set for the specified
VLAN:
1 = N:1 bridge mode
2 = 1:1 VLAN cross-connect mode with tagged uses frames.
show macmode VLANID
Config/
Bridge
Shows the current MAC mode of specified VLAN-ID.
Changing a VLAN to Enhanced MAC Mode
Perform the following tasks in order to change the MAC mode of VLAN:
1. Check if the VLAN fulfills the requirements for the new MAC mode.
2. Change the GPON MAC mode. The existing VID mapping entries will be deleted
automatically.
3. Create default VID mapping entries.
Example:
The following commands set the MAC in enhanced mode and assign the MAC mode 2
to VLAN 100:
SWITCH(bridge)#gpon-mac-mode enhanced-mac
SWITCH(bridge)#show base-settings
SWITCH(bridge)#macmode 100 2
SWITCH(bridge)#show macmode 100
13.5
MAC Table
There are two hardware address types that are registered in a MAC table: dynamic MAC
addresses and static MAC addresses. A static MAC address can be configured by the
operator and remains unaffected even after the system was rebooted. Dynamic MAC
address entries of this table are formed during a learning process in upstream direction.
13.5.1
Dynamic Addresses
Enabling of Address Learning
Dynamic addresses are automatically added to the MAC table and dropped from it when
they are not in use.
Command
Mode
mac learning-uplink { enable I disable }
Bridge
Function
MAC learning configuration (only uplinks affected).
enable (default) / disable MAC address learning on uplink
ports .
MAC Aging-Time
If an NE was not accessed during a specified interval called “MAC aging-time”, its registered MAC address will be deleted from the table.
154
Id:0900d8058023fad7