Download Operation Manual CLI

ARP Table
Operation Manual CLI
SWITCH (config)# show arp
--------------------------------------------------------Address
HWaddress
Type
Interface
-----------------------------------------------------------10.254.254.105
00:bb:cc:dd:ee:05 DYNAMIC
br4094
10.1.1.1
00:00:cd:01:82:d0 DYNAMIC
mgmt
SWITCH (config)#
20.3
ARP Alias
For security reasons, the communication between hosts connected to the same switch
may be impossible. However, the hiX 5750 R2.0 can use ARP alias to connect hosts
with each other by supporting the response of ARP requests from the host network
through the concentrating switch.
To register a range of IP addresses from the host network in an ARP alias, use the
following command.
Command
arp-alias A.B.C.D A.B.C.D
[ XX:XX:XX:XX:XX:XX ]
Mode
Config
Function
Registers IP start and end address and MAC address in
ARP-alias to make user’s equipment response ARP
request.
Use the no parameter with this command to delete
specified IP address range from ARP table.
g Unless you have specified a MAC address, the MAC address of user’s equipment
will be used for ARP response.
To view ARP alias, use the following command.
Command
show arp-alias
Mode
Privileged/
Config
Function
Shows registered ARP-Alias.
Example of configuring ARP alias by registering IP addresses from 10.1.1.2 to 10.1.1.5.
SWITCH (config)# arp-alias 10.1.1.2 10.1.1.5
SWITCH (config)#
194
Id:0900d805801da7a0