Download EMCALC 2000 User Man..

Start Data Collection
•
•
•
•
•
62
Remove the plastic battery cover on the EMDEX II meter. Leave the battery cover
off for the remainder of this Quick Tour.
Turn the power switch (located under the battery cover) to the “On” position.
After a brief power-up sequence, the meter will display “STANDBY” on its LCD
screen. If a LINDA program was burned into your meter, then it will display the
word “LINDA”. If “LINDA” is displayed, then you cannot perform this Quick Tour
unless you first upload the Standard operating program into your meter. See the
topic titled "Change EMDEX II Parameters" in the Communications section of this
document.
Press the “+” toggle button on the front panel of the EMDEX II meter one time to
enter run mode. The word “Run” will be displayed on the LCD.
Press the “EVENT” button on the front panel of the EMDEX II meter one time to
start data collection. The text “start 1” will be displayed briefly, followed by the text
“Rb=X.X”. Where X.X is some number. These numbers represent the resultant
magnetic field intensity currently being detected and stored by the meter.