Download EasyLogger for DS1M12 Help

Using EasyLogger for DS1M12
3.4
Sub Panel Functions
3.4.1
Signal Generator Window
34
Selecting the SignalGen option from the run menu or clicking the Signal Generator button from the
main toolbar displays the configuration window for the signal generator output (shown below).
This allows the operator to select a pre-defined waveform from
·
·
·
·
·
·
DC output
Sawtooth
Square
Sine
Triangle
Pulse
Each of these waveforms may be adjusted in amplitude, ground offset and frequency. In addition,
there is an option to load a custom waveform from a .CSV file. This file should have one column of
millivolt values, one for each sample. The maximum number of samples permitted is 1024. If the
file contains more than 1024 data points, only the first 1024 points will be used to generate the
pattern.
© 2006 USB-Instruments