Download Operator`s Manual

Transcript
Lubrication and maintenance
5 LUBRICATION AND MAINTENANCE
Warning!
Never stand between the front of the tractor and
the loader's cross tube.
Fig.91 Never stand between the front of the tractor and the
loader's cross tube.
5.1 Lubrication points
Lubricate the following grease nipples with universal
grease every 10 operating hours.
Warning!
Risk of crushing and jamming
The loader may fall downwards.
Lower the loader to the ground before you start
greasing.
NA on 100c/140c
Grease nipples on every pivot pin on both sides of the
loader.
5.2 Storage
Apply a thin layer of grease on visible piston rods in order
to protect them.
NA on 100c/140c
Fig.92 Grease nipples on every pivot pin on both sides of the
loader.
5.3 Hydraulic system
Check the oil level in the tractor hydraulic oil tank
regularly, with the loader lowered to the ground. Use the oil
specified in the tractor's operator's manual.
5.3.1 Hoses and cylinders
Read this before checking the hydraulic system for leakage:
69638
Warning!
Pressurised oil.
Hydraulic oil at high pressure can be injected
into the body in the event of leakage and cause
serious injury, blindness or fatality. Leakage may
be invisible.
Use approved protective safety glasses and
protect the skin using strong leather gloves for
example. Use cardboard or wood for leakage
detection. If fluid has entered the skin then it
MUST be removed within a couple of hours by a
doctor who can treat this type of injury.
Fig.93 NEVER use fingers or hands for leakage detection.
37