Download AB7614 User Manual - Support

Transcript
Configuration 3-2
Connecting to the BridgeWay Module
Connect the PC running BWConfig to the BridgeWay module using a standard
Null-Modem (pins 2 and 3 swapped) serial cable between the PC serial port or
USB adapter and the 9-pin D-Sub connector on the module. It does not matter
which PC serial port you use, BWConfig will scan each available port and detect
the connection automatically. No serial port configuration is required; BWConfig
will automatically set the baud rate.
Starting the Tool
Launch BWConfig from the BridgeWay Configuration folder in the Windows
Start Menu.
When BWConfig is started, it will attempt to locate a BridgeWay module on one
of the PC serial ports. If a module is found, the status area of the tool will be
updated to show the module type and status of the module that was located.
If a module is not connected to the PC, or is powered off, when the tool is started,
the status area will indicate that no module was detected. Make sure that the module is powered and the connection is made, then press the Refresh button on the
BWConfig tool bar; this will cause the tool to rescan the serial ports for a module.
© 2011 Pyramid Solutions Inc.
Publication PUB-AB7614-005