Download GDS-2000

Remote Control
4. (For GPIB only) To select the address, press
F2 repeatedly.
5. Connect the USB/RS232C/ GPIB cable to the
rear panel.
RS-232C
USB
GPIB (Optional)
1 2 3 4 5
6 7 8 9
To install, power off the
2: RxD, 3: TxD, 5: GND
device and plug the
1, 4, 6~9: No connection
GPIB card into the slot.
Functionality
Check
Run this query command via a command
terminal such as DOS prompt.
*idn?
This should return the Manufacturer, Model
number, Serial number, and Firmware version in
the following format.
GW, GDS-2064, P920130, V3.01
Range
Baud Rate (RS232C)
2400, 4800, 9600, 19200, 38400
Stop Bit (RS232C)
1, 2
Parity (RS232C)
Odd/ Even/ None
Address (GPIB)
1~30
GPIB
Constraints
Keep these rules when using GPIB interface.
* Altogether less than 15 devices & 20m cable
length, 2m between each device on the bus
* Unique address assigned for each device
* At least 2/3 of the GPIB devices turned On
* No loop or parallel structure allowed
103