Download SCC Quick Start Guide

Figure 17 shows the SC-2350 carrier with the SCC modules installed.
1
2
3
4
5
11
8
10
6
7
9
1
2
3
4
5
6
Cover Screws
Screw Terminal Block
TEDS Screw Terminal
SCC Module—Analog Output
SCC-PWRXX
D-Sub Panelette
7
8
9
10
11
SCC Modules—Analog Input
Connector Block Sockets
TEDS Screw Terminal: RETURN Screw Terminal
TEDS Screw Terminal: DATA+ Screw Terminal
Strain-Relief Panelette
Figure 17. SC-2350 Carrier Installation Diagram
Connecting Digital Signals (Optional)
The SC-2345/2350 has a 42-position, triple-row screw-terminal block for
connecting to E Series DAQ device digital signals. The terminal block
can connect to P0.<0..7>, +5 V, D GND, PFI <0..9>, CTR <0,1> GATE,
CTR <0,1> OUT, CTR <0,1> SOURCE, AI SENSE, FREQ OUT,
EXTSTROBE, and AI HOLD COMP. The SC-2345 Quick Reference
Label identifies the location of each signal on the terminal rows A to C.
The terminal label numbers correspond to the pin number location of each
signal on the 68-pin E Series connector. Refer to the E Series DAQ device
user manual for more information about this connector.
© National Instruments Corporation
21
SCC Quick Start Guide