Download View/Open - Calhoun: The NPS
Transcript
read of ITL status. In Figure 6-11, if ITL is true, control and if false, the right path is flow follows the left path, traversed. If ITL acceleration disabled. is is true, input the ADC the software, to is enabled, and the current ADC is After the ADC is disabled, control and information flow continue along the ITL path toward possible detonation. If ITL the false, is ADC is enabled, acceleration bias is sent to the software, disabled. current and the ADC is The control and information flow then updates the acceleration and loops back to recheck ITL status. Although there are four ADC instantiations in the net, the SA system contains only one physical device. The ADC is enabled/ disabled via one set of input places and feedback to the system is via a single set of output places. Petri net is nondeterministic, there must be methodology to ensure correct path maintenance. a Since a modeling The method we devised is to place system locks at module entry and exit points whenever there was a path choice. This lock guaranteed that only the correct transition would be enabled upon module output. Figure 6-12 shows the ADC portion of the final system net with path locks in place. 59