Download View/Open - Calhoun: The NPS

Transcript
read of ITL status.
In Figure 6-11,
if ITL is true,
control
and if false, the right path is
flow follows the left path,
traversed.
If
ITL
acceleration
disabled.
is
is
true,
input
the
ADC
the
software,
to
is
enabled,
and
the
current
ADC
is
After the ADC is disabled, control and information
flow continue along the ITL path toward possible detonation.
If
ITL
the
false,
is
ADC
is
enabled,
acceleration bias is sent to the software,
disabled.
current
and the ADC is
The control and information flow then updates the
acceleration and loops back to recheck ITL status.
Although there are four ADC instantiations in the net,
the SA system contains only one physical device.
The ADC is
enabled/ disabled via one set of input places and feedback to
the system is via a single set of output places.
Petri
net
is
nondeterministic,
there must be
methodology to ensure correct path maintenance.
a
Since a
modeling
The method
we devised is to place system locks at module entry and exit
points
whenever
there
was
a
path
choice.
This
lock
guaranteed that only the correct transition would be enabled
upon module output.
Figure 6-12 shows the ADC portion of the
final system net with path locks in place.
59