Download Operating manual

IDEA
Operating Manual - English
Reading
KEY READING
Original on right
Clamp: S100 A - B Stop:0
Adapt. E16
[START]
Is adaptor E16
installed ?
Yes=START
max 31 mm
No=STOP
max 7 mm
max 15 mm
1) Press on the grip lever of the fixed clamp (A) and fit the centring
device E16 so that it protrudes towards the mobile clamp (B) (fig.
82). Release the grip lever.
2) Press on the grip lever on the mobile clamp (B) and fit the key so
that the hole in the stem is up against the centring device E16 (fig.
83). Release the grip lever.
3) Hold the key head with one hand and the end of the centring
device with the other and push the key up against the stop 0 (A).
4) The ideal position for the mobile clamp (B) is when there is a
distance of 3 mm min. and 15 mm max. between the bit and inner
side of the mobile clamp (B).
Clamp: S100 A-B = indicates the clamp (S100) into which the key
must be fitted, and which jaw to use.
Stop 0 = reference or point for positioning the key on the reading
clamp.
Adapt: E16 = adapter for positioning the key (female) from the tip
(only for reading).
ATTENTION: make sure that the bit is up against the Stop 0 (A).
Fig. 82
Pressing Start shows:
Left blank
Brass
Clamp: S1-K1
Stop:0
Cutt: 1.25
Adptt: E15
pcs. = 1/1
[START]
Is adaptor E15
installed ?
No=STOP
Yes=START
Fig. 83
58
Copyright Silca 2004
Note:
Maximum dimensions of keys for
Reading from the original:
- Max. stem thickness = 7 mm
- Max bit length = 31 mm
- Max. bit height = 15 mm
If these conditions are not observed,
the machine will produce the error
“Key cannot be decoded”.