Download MX100-TG USER MANUAL
Transcript
8 TROUBLESHOOTING This chapter contains information to help you solve problems that may occur while installing and using the MX100-TG gateway. GETTING HELP If, after installing and configuring your New Rock equipment, you cannot establish Technologies to or from the unit, carefully review the information in this book and in the other books prior to calling Customer Support (CS). Before going any further, ensure that you have checked the following: y y y y MX100-TG User Manual Console Port configuration. Verify that the baud rate of your terminal is set to 9600 bps. Power reset. When cycling power, be sure to leave the power off for a minimum of 30 seconds before reapplying power to the unit. Command review. Review the MX100-TG gateway commands in the Configuration chapter. Software version. To ensure that you have the latest enhancements and product features, New Rock ships every unit with the latest software version. Therefore, when you are installing or reinstalling units into your system, verify that each unit is equipped with identical software versions. 77