Download EPM 2200

Transcript
CHAPTER 4: ELECTRICAL INSTALLATION
4.2.11 (8) Current-Only Measurement (Three-Phase)
For this wiring type, select 3 EL WYE (3 Element Wye) in the meter programming setup.
FIGURE 4–12: Current-Only Measurement (Three-Phase)
Note
4–16
Even if the meter is used only for current measurement, the unit requires a AN volts
reference. Please ensure that the voltage input is attached to the meter. AC control power
can be used to provide the reference signal.
EPM 2200 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE