Download User Manual - Envirostar
Transcript
Starting Before starting the engine check the oil level (See above) Do not use a pressurised starting fluid. Always start, store, use and fuel the ENVIROSTAR in a level position. Before Attempting to starting the ENVIROSTAR check that the emergency stop switch has not been activated. To reset turn the switch in the direction indicated by the arrows. Also check that the access panel safety switches are being correctly activated. See section 8 for further details on the safety systems (See diagram in Section 7.2) 1. 2. 3. 4. Move the choke control (1) to the CHOKE position. Move the throttle control (2) to the FAST position. Turn the fuel shut off valve (3) to the ON position. Turn the key to the start position until the engine starts, then release, repeat if necessary. 5. When the engine is running shut off the choke and set the speed to the desired RPM for the work being undertaken. 6. If the battery has become discharged and the engine will not turn over, the engine can be started manually. 7. If engine floods, set choke to OPEN/RUN position, place throttle in FAST and crank until engine starts. Manual start 1. Proceed as above; steps 1 to 3. 2. Grasp the rope handle pull cord slowly until resistance is felt, then pull rapidly to overcome compression, prevent kickback and start the engine. 3. Repeat if necessary with the choke in the RUN position and the throttle set at FAST. 4. When the engine is running set the speed to the desired RPM for the work being undertaken. 27