Download Estimated maintenance time 10 minutes.

User manual instructions: Evo model cutting tables
Pneumatic plant condition check

I-026
Estimated maintenance time 20 minutes.
Pneumatic plant
To ensure the perfect operation of the cutting table, it is advisable to do a yearly check of the conditions and state of
all the tubes, pneumatic fittings and of the electrovalves present on the frame.
If air leaks can be felt near the quick coupling fittings their replacement is advised.
If the leak continues, replace the air tube. The electrovalves are gathered on the tubular structure.
The plant check must be carried out yearly.
PREPARATION OF THE MACHINE
When operating on the table to check the pneumatic plant, it is compulsory:



To remove any pieces of glass present on the machine by using gloves adequate for handling glass.
To lift the panel and to insert the safety tips.
To remove the electric and pneumatic energy to the machine.34
ATTENTION!
This type of operation must be carried out also with the panel high. It is compulsory to insert the safety35 tips
which block the panel at the base before the check.
REMAINING RISKS
Bumping the table carpentry.
Compressed air.
Individual protection devices to be used:
 Protective helmet.
 Protective glasses.
As well as:



Light leather five finger gloves.
Adequate clothing.
Accident prevention shoes.
(anti-cut gloves are not compulsory for handling glass)
DESCRIPTION OF THE OPERATION





34
35
Access the working area scrupulously keeping to the procedures reported in the section D-Access to the
machine working areas in this manual.
Check that all the pneumatic components and above all the tubes are well inserted in the fittings, that they
are not bent or squeezed, and have no cuts or holes.
Carefully check the length of all the tubes, including those inside the conduits.
To control the fittings and anchoring, lightly pull the tube out of the fitting and make sure that it remains well
anchored.
Having finished the operation, remove the safety tips, leave the table working area making sure no one is
inside, restore energy to the machinery following the operations described in this manual in section EExclusion-restoration of energy, restore the operator protection circuits and lower the table using the
key on the control panel.
Consult section E- Exclusion-restoration of energy in this manual.
Consult subject on page I-45.
I-36
Rev.1
Date: 18/01/2010
Everything contained in this instruction booklet is strictly reserved, confidential and must not be disclosed in any way.
Code: EVO-UM-IN