Download E2 User Manual.book - Emerson Climate Technologies

Alarm Name
Default
Priority
IRLDS: Absorption Data Error
20
IRLDS: ADC Error
20
IRLDS: Data Error
20
IRLDS: Detector Data Error
20
IRLDS: Drift Fault
20
IRLDS: General Fault
20
IRLDS: Line/Filter Flow Fault
20
IRLDS: Pressure Data Error
20
IRLDS: Self-Test Failure
IRLDS: Temperature Data Error
20
20
IRLDS: Unknown Error
20
IRLDS: Voltage Data Error
20
ISD Missing Phase Lockout
20
ISD Missing Phase Trip
99
ISD Oil Pressure Lockout
20
ISD Welded Contactor
20
ISD Compressor Module Failure
20
C-8 • E2 RX/BX/CX I&O Manual
Definition
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
A zone on an IRLDS unit has a dirty filter or a
crimped tube.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
An IRLDS has failed its self-test procedure.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
The IRLDS has experienced an error not recognized
by the E2.
An internal error has occurred in the IRLDS. Check
the IRLDS display for error code information, and
call Retail Solutions service.
After 10 consecutive missing phase trips, the compressor is locked out on missing phase lockout.
If any of the 3 phases of power is missing after the
compressor is called to be on, this advisory is generated.
If we have been in Low Oil warning for 2 minutes we
will lock out the compressor.
If there is voltage on the 3 phase sense inputs 0.5 seconds after the compressor is called to be off, this
advisory is generated.
A hardware failure has occurred in the ISD module.
026-1610 Rev 17 10-JUL-2014