Download Manual

PG
subroutine PRINTCURVES
15.5
September 2000
15.5.1
Printing special items related to the mesh (subroutine PRINTCURVES)
In this section we describe some special subroutines to print selected items from the mesh. The
following subroutines are available:
PRINTCURVES (15.5.1]), prints the coordinates of the user points or the curves of the mesh,
together with curve and node numbers.
15.5.1
Subroutine PRINTCURVES
Description
prints the curves or the user points of the mesh
Heading
subroutine printcurves ( ibuffr, buffer, kmesh, iprins )
Parameters
INTEGER IBUFFR(∗), KMESH(∗), IPRINS(10)
DOUBLE PRECISION BUFFER(∗)
IBUFFR Standard integer buffer array as stored in blank common. The reason to
put this parameter in the parameter list is that in this way blank common may be
avoided.
BUFFER Standard double precision buffer array. In fact this is exactly the same array
as IBUFFR.
KMESH Standard SEPRAN array containing information about the mesh. KMESH
must have been filled before by a mesh generation subroutine or by a subroutine
that reads the mesh.
IPRINS Integer array to be filled by the user with the following information:
1 Indication if user points (1) or curves must be printed (2)
2 IINNER Information of how the curves must be printed
1 only the outer boundaries are printed
2 only the inner boundaries are printed
3 all boundaries are printed
3-10 Not yet used (Fill zeros for future developments).
Input
The arrays KMESH and IPRINS must have been filled.
The arrays IBUFFR and BUFFER must have been filled.
Output
Print of the coordinates of the user points or curves