Download Sonnox Restore QuickStartGuide-1-2

Transcript
4.2
Quick
Start
Guide
4
THE OXFORD DENOISER
allows the noise reduction to be modified in smaller frequency bands. Listen to the
audio signal, and bring down the grab handles on the yellow curve. Listen to the
removal of noise in that band, and carefully balance against the preservation of the
audio signal.
2. Now listen to the critical frequencies of the material to evaluate whether you could
adjust the red threshold
bias
curve to be more sympathetic to these parts. This
would mean slightly lowering the threshold bias handles in the critical regions of the
frequency spectrum to reduce noise reduction there and preserve more of the
original audio, and perhaps to lift the bias controls in the HF area to remove more
hiss.
3. If you have a constant noise floor, try to find a segment with no signal and use
Freeze mode. All the threshold profile and noise reduction biasing controls will help
you modify the curves.
4. Surprisingly good results can be obtained quickly using a manually-shaped fixed
curve. Select Manual mode. Use the Colour control to modify the noise profile at
LF, perhaps by mimicking a pink noise curve. Use the Air control to modify the noise
profile at HF, which can help preserve HF signal frequencies. The noise profile can
be further shaped in smaller frequency bands by using the bias curve handles.
www.sonnox.com
16
Go
to
contents