Download OPERATING MANUAL

Line Out
1. Connect the RCA line out jacks to auxiliary input sockets of your home amplifier device.
Make sure to match the socket colors with the jack colors.
2. Connect the unit’s power cord to the household outlet. Also, power on your amplifier
device and adjust its volume level.
Line In
1. Rotate the POWER/VOLUME knob clockwise until hear a “click” sound to turn on the
unit.
2. Select LINE IN by turning the FUNCTION SELECTOR KNOB.
3. Connect the RCA line out jacks to auxiliary input sockets of your home amplifier
device. Make sure to match the socket colors with the jack colors.
Earphone Jack
To listen music from earphone/headphone, connect your earphone/headphone into the
earphone jack.
External Speaker Jack
To play with external speakers, connect the external speaker wires to the external speaker
jack, which locate at the back of the unit
Internal Speaker On/Off Switch
To select playback from internal speaker, slide the switch to “On” position.
WARNING! Risk of hearing damage
• Set a low volume on the playback device before you connect the headphones to
the sound source.
• Avoid excessive volumes, particularly over extended periods or in the case of
frequent use. Excessive volume can result in permanent hearing damage.
Re-mark :
ERP2 mode: When the unit does not receive any Audio signal from Phono and
Line-in in around 10 minutes, the unit will automatically enter standby mode. In
order to re-activate the unit, please turn off the unit and turn on again to resume
normal operation.
9