Download User`s Manual
Transcript
BATTERIES 03 3.5.4.1 Check all screens and/or filters on water filling supplies Clean or replace all filters and line strainers as necessary. Failure to do so can cause a reduction in the water pressure and flow rates needed to operate the water filling system properly. A filter screen can be found on the inlet of all regulators, and a line strainer on all supply hoses. Pump powered water supplies include a strainer on all suction hoses. For deionizers, be sure to replace the filter cartridges as indicated by the water quality light. Consult your water supply instructions for detailed instructions. 3.5.4.2 Inspect the condition of all tubing connections and couplers and the water filling system Make sure that all parts are in good working condition and are secure, leak free and properly connected. The coupler must have an O-ring and dust cover properly attached. 3.5.5 Cleaning batteries • Clean the top of the battery, the terminals, and all connections with a cloth or brush with a solution of baking soda and water (ensure that none of the baking soda solution gets inside of the battery). Use 1lb of baking soda for 1 gallon of water (120g for 1 litre of water). • Rinse with plain water and dry the battery • If possible, add a thin layer of terminal protector (Available at most battery dealers or auto parts stores). • Always keep batteries dry and clean. 3.5.6 Removing corrosion from battery poles Make sure that the poles and the surface of batteries are clean at all times. To remove corrosion, add a solution of water and baking soda. Use 1lb of baking soda for 1 gallon of water (120g for 1 litre of water). Do not allow any cleaning solution to enter the battery cells. If baking soda is not available, a terminal brush can be used to clean the battery poles. Terminal brushes can be found at most local hardware supplies. 23