Download Gigaset E310

Gigaset E310/E310A (Panther) / MEA EN / A31008-M2301-A601-1-UZ19 / appendix.fm / 11.05.2012
Environment
Gigaset E310A only:
No time is specified for a message
in the calls list.
Date/time have not been set.
¤ Set the date/time (¢ page 15).
During remote operation the
answering machine does not
respond to key 9.
The system PIN is still set to 0000.
¤ Set the system PIN to something
other than 0000 (¢ page 50).
The answering machine reports
"Incorrect PIN!" during remote
operation.
You have entered the wrong system
PIN. The connection is terminated.
¤ Call answering machine again.
The answering machine will not
record any messages/stopps the
recording of a personal announcement.
The memory is full.
¤ Delete old messages.
¤ Play back and delete new messages (¢ page 36).
Version 5, 03.04.2011
Exclusion of liability
Some displays may contain pixels
(picture elements) which remain
activated or deactivated. This is
completely normal and does not
indicate a fault.
60
Authorisation
This device is intended for analogue phone
lines outside the European Economic Area
(with the exception of Switzerland) depending on national type approval.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the Declaration of Conformity is
available at this Internet address:
www.gigaset.com/docs
Environment
Our environmental mission
statement
We, Gigaset Communications
GmbH, bear social responsibility
and are actively committed to a better world. Our ideas, technologies
and actions serve people, society
and the environment. The aim of our
global activity is to secure sustainable life resources for humanity. We
are committed to a responsibility for
our products that comprises their
entire life cycle. The environmental
impact of products, including their
manufacture, procurement, distribution, utilisation, service and disposal, are already evaluated during
product and process design.