Download Alice - PDS Small Bodies Node
Transcript
Rosetta-ALICE User Manual time-resolved acquisitions using relatively bright targets in the Alice FOV. At the conclusion of this acquisition period the total amount of generated data can be further reduced by selecting only events that have occurred within up to eight separate windows for downlink. Count Rate Mode. In this mode, the acquisition memory is again used as a one-dimensional linear array of 32,768 entries. The count rate mode is designed to periodically (configurable between 3 ms and 12 s) collect the total detector array count rate sequentially in the linear memory array, as if the entire instrument were an FUV photometer. This mode allows for high count rates from the detector (up to 10 kHz), without rapid fill up of the array. It does not, however, retain any spatial or spectral information for broadband photometric studies. Depending on the required periodic acquisition rate, total acquisition durations of up to 98 seconds to 100 hours are possible. 3.1.7 Detector Acquisition Durations The actual start and end time of any acquisition is reported in the header of the science data dump, both specified in instrument (spacecraft) MET. The Alice post-processing chain (i.e. Lima, Mike and November) includes this information in the produced FITS files and calculates the acquisition duration from these numbers as the difference between the start and stop times. For histogram and pixel list acquisitions this calculated number represents the best available knowledge on the actual duration of the acquisition. The acquisition duration is not always exactly the same as the commanded acquisition time. This is easy to understand for special cases where an acquisition was terminated early either by user command or because a safety condition occurred, but also for the nominal acquisitions there will be a difference between commanded and actual acquisition time. The reason for this is that the instrument software controls the acquisition hardware in such a way that also adds a kind of granularity to the acquisition duration, which is dependant on the specific acquisition mode. For the four different cases the consequences of this quantization will be discussed. These timing measurements apply to each of the separate acquisitions within a MAD commanded (multi) acquisition sequence. The start time of an acquisition within a MAD multi acquisition sequence with a fixed cycle duration is checked every 0.5 seconds. This means that the start of an exposure within a multiple acquire cycle may occur up to 0.5 seconds later than expected from the commanded cycle duration. This start time error is not cumulative though; the start times of the multiple exposures are all related to the initial acquisition command start time. 3.1.7.1 Histogram Acquisition During a histogram acquisition, in parallel to the histogram acquisition a coarse count rate data set of up to 100 elements is acquired. This count rate data is included in the header of the data dump and the Alice post-processing chain places this data in the second extension of the generated FITS file. The minimum time resolution for this count rate acquisition is 100 ms for acquisition durations less than 10 seconds and the maximum is 25.5 seconds for acquisitions of 2550 seconds or more. For shorter acquisitions, the 100-element count rate buffer is only partially filled and for acquisitions longer than 2550 seconds (42.5 minutes) only the initial part of the acquisition is covered in the count rate measurements. This count rate measurement interval also determines the granularity of the histogram acquisition end time check. This means that for short histogram acquisitions the commanded end time is checked every 100 ms but for longer acquisitions the check is performed less frequently. The worst case situation occurs for acquisitions longer than 2550 seconds for which the termination condition is only checked once every 25.5 seconds, this means that worst case such an acquisition could continue up to 25.5 seconds longer than commanded. Except for the very short acquisitions (less than 10 seconds), where the acquisition duration may last up to 100 ms longer than planned, the maximum acquisition extension is always less than 0.4% of the commanded acquisition duration. In all cases the reported start -40-