Download operating manual cost control

Transcript
11.0 SETTING UP:
Before plugging the Cost Control into the mains socket and any appliances into it, the values must be
set.
Firstly, enter the “TOTAL COST” display by pressing the “COST” key to alternate between
“COST/D”, “COST/M and “COST/Y” displays. Now check that all the values displayed are set to
zero as follows: (as illustrated below).
1.
2.
Any preset values in the “TOTAL COST” display that the user has not set in must be reset to
zero to ensure accurate readings. To do this, simply press and hold down the “COST” key (for
approximately 4 seconds) and all values with the exception of Tariff (cost per kilowatt hour) will
be reset to zero.
Once all the values displayed are set zero in the “TOTAL COST” display, then press the
“TARIFF” key to enter the Tariff setting mode.
24