Download Instruction Manual

Transcript
3. Glue aileron and outer flaps into the main wing
Push the aileron/outer flap tight against the wing. Flex the aileron and apply enough thin CA to fully penetrate the
hinge. Apply CA to both the top and bottom of the hinge. Important: Do not use accelerator when hinging. The
CA must be allowed to soak into the hinge for the best possible bond between the hinge and surrounding wood.
4. Check and break in aileron and outer flaps
After the CA has fully cured, gently pull on the wing and aileron to make sure the hinges are secure. If not, re-glue
the hinges.
To break in the hinges, you will need to flex the aileron up and down a number of times.
Copyright@2015 - Roban Limited – All rights reserved