Download Instruction Manual

Transcript
STEP 1 HINGING FLAPS AND AILERONS
1. Apply instant CA glue to aileron, outer flap, and pin hinge
Use a rotary tool and 1/16-inch (1.5mm) drill bit to drill a 1/2-inch (12mm) deep hole in the center of each hinge slot.
This provides a tunnel allowing the glue used to secure the hinges to fully penetrate the hinge. Slide the hinges
back into the ailerons and outer flaps and apply CA glue.
2. Install the aileron and outer flaps into the main wing
Slide the aileron and outer flap into position on the wing. Make sure the inboard edge of the flap near the center
of the wing, and the outer tip of the aileron near the wing tip do not bind against the wing. Also make sure the flap
and aileron do not bind against each other.
Copyright@2015 - Roban Limited – All rights reserved