Download TESEQ Modula - PH

Modula 6100
9.7
Setting the IP-address in the Modula using the PDA
As already mentioned above, the IP-address in the Modula only needs to be altered under special
circumstances. Should a change become necessary then the task can be carried out as follows.
The MHC must first be initialised and communication established with the Modula before this procedure
can be carried out. If no communication exists, please carry out the procedure as explained in chapter 10
cold start and Initialisation.
1.
Open the program “Set Master IP”
The TCP/IP configuration menu appears. Click the “Keyboard” icon.
2.
Once communication has been established, “Online” appears in the “Mode”
field.
3.
The “IP-Address“ field is activated by clicking on it. A new address can now
be entered by means of the opened keyboard. The same procedure is also
used for the “Subnet-Mask“ field. The setting shown in the “TCP-Port:” field
should not be altered.
Incorrect information is shown in the “IP-Address“ and “Subnet-Mask“ fields when
the “SetMasterIP“ window is opened. This information does not correspond with
the address that has been set in the Modula. This is a software error that will be
eliminated in the next version.
4.
The new address can be transferred to the Modula by clicking the ”Write”
button. The keyboard must first be hidden before the “Write” button can
become visible. The successful transfer of the new address is indicated by the
message “ACK;0“. The message must be acknowledged by clicking on it.
53/77