Download IC-E92D Instruction manual

Transcript
New2001
GPS/GPS-A OPERATION
NOTE: Set the GSV sentence to OFF when sending the
GPS message to conventional digital transceivers
(IC-E2820, IC-E91, IC-V82, IC-U82).
The GSV sentence is incompatible with them.
Those transceivers will not display GPS messages
properly if sent as a GSV sentence from the ICE92D.
8
e Rotate [DIAL]† to select the desired character or symbol.
• Push [A/a](3) to change the character group from “AB” (alphabetical characters; capital letters), “ab” (alphabetical characters;
lower case letters), “12” (numbers) and “ !” ” (symbols) in sequence.
r Push [ ](6) to select 2nd digit, then rotate [DIAL]† to select the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
t Repeat the steps r and t to enter the desired message.
D GPS message programming
• Up to 20-character messages can be set.
q Enter “GPS” in message/position set mode.
GPS MESSAGE
rDATA:
❮MENU screen❯ ➪ ❮MESSAGE/POSITION❯ ➪ ❮GPS❯
(Push [MENU/
]) (Rotate [DIAL]†, then push [ ](5)‡.)
:SET
:SEL
:CUR
• GPS MESSAGE screen is displayed.
GPS MESSAGE
rDATA:
AB
†
:SET
:SEL
:CUR
AB
Hello!†
Hello!
CLR:CLR
A/a:CHAR
y Push [ ](5) to store the message.
u Push [MENU/
] to return to frequency indication.
CLR:CLR
A/a:CHAR
w Push [ ](6) to select the message edit condition.
• The 1st digit of the message blinks.
†[DIAL]
↔ [ ](2)/[ ](8)
‡[
](5) ↔ [ ](6)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
61