Download SYS68K/CPU-60 Technical Reference Manual

Appendix to VMEPROM
Driver Installation
To install driver
To install the ISCSI-1 driver use the install command with the appropriate address (see “Software version dependent addresses” on page 151):
? INSTALL W,$FF029700
The default base address of the ISCSI-1 controller is A0.000016 in the
standard VME address range. This is the address FCA0.000016 for the
CPU board. To this setup no changes have to be made. The ISCSI-1 driver uses interrupts by default. This cannot be disabled. Please make sure
that the interrupt daisy chain is closed so that the controller can work
properly.
7.1.6
Local SCSI Controller
VMEPROM supports up to three Winchester disk drives together with
the local SCSI Controller. The Winchester drives are not installed automatically.
The VMEPROM FRMT command must be used for defining the following
factors:
• The physical structure of the drive (i.e., number of heads, number of
cylinders, drive select number, etc.)
• The bad blocks of the Winchester drive
• The partitions to be used
If this setup is done once for a particular drive, the data is stored in the
first sector of the Winchester and automatically loaded when the disk
controller is installed in VMEPROM. When viewing the VMEPROM
banner, the driver for the local SCSI controller is already installed. This
driver needs memory for hashing. The storage for the hashing buffers is
allocated at the end of memory.
SYS68K/CPU-60
Page 157