Download Sigma-II User Manual

Sigma II User’s Manual
Chapter 5: Parameter Settings and Functions
Allocating Other Input Signals
Input signal allocation can be changed as shown below.
Input Signal
Name
Proportional Control Reference
(/P-CON)
Forward Run Prohibit
(P-OT)
Reverse Run Prohibit
(N-OT)
Parameter
Applicable
Logic
ON
(low level)
OFF
(high level)
Alarm Reset
(/ARM-RST)
Forward Current Limit
(/P-CL)
Number
Pn50A.2
ON
(low level)
2
Inputs the specified signal from SI2 (CN1-42).
3
Inputs the specified signal from SI3 (CN1-43).
4
Inputs the specified signal from SI4 (CN1-44).
5
Inputs the specified signal from SI5 (CN1-45).
6
Inputs the specified signal from SI6 (CN1-46).
7
Sets the specified signal to always enabled.
8
Sets the specified signal to always disabled.
9
Inputs the specified inverse signal from SI0 (CN1-40).
A
Inputs the specified inverse signal from SI1 (CN1-41).
B
Inputs the specified inverse signal from SI2 (CN1-42).
C
Inputs the specified inverse signal from SI3 (CN1-43).
D
Inputs the specified inverse signal from SI4 (CN1-44).
E
Inputs the specified inverse signal from SI5 (CN1-45).
F
Inputs the specified inverse signal from SI6 (CN1-46).
Pn50B.2
Pn50C.0
—
Pn50C.1
Contact Input Speed Control
Selection
(/SPD-B)
Pn50C.2
Control Mode Selection
(/C-SEL)
Pn50C.3
Gain Switching
(/G-SEL)
Inputs the specified signal from SI1 (CN1-41).
Pn50B.1
Contact Input Speed Control
Selection
(/SPD-D)
Reference Pulse Inhibit
(/INHIBIT)
Inputs the specified signal from SI0 (CN1-40).
1
Pn50B.0
Pn50B.3
Zero Clamp
(/ZCLAMP)
0
Pn50A.3
Reverse Current Limit
(/N-CL)
Contact Input Speed Control
Selection
(/SPD-A)
Description
Setting
0 to F
Same as above.*
Pn50D.0
ON
(low level)
Pn50D.1
Pn50D.2
Note: "Same as above” means that input signals and terminals SI0 to SI6 are enabled or disabled
through parameter settings 0 to 8.
5-56