Download USER`S MANUAL - Mouser Electronics

Operation
Operation
CLR
CLR
Chapter 3
Display
CLR
Explanation
Press the Clear Key three times to delete the displayed bank
number.
The bank number display will start flashing when the Clear Key
is pressed three times (which means the bank number is ready
to be deleted).
Note If the Clear Key is pressed once, the ON and OFF angle
display will start flashing (which means the step is ready
to be deleted). If the Clear Key is pressed twice, the cam
number will start flashing (which means that that cam
number is ready to be deleted). If the Clear Key is
pressed four times, the display will return to the original
display (nothing will be deleted).
While the bank number display is flashing, press the Set Key to
delete the bank number that is flashing.
SET
Once the cam number has been deleted, the ON and OFF
angle display will be “-- -- --” (which means data can be input).
D Deleting All Cam Programs
Operation
Display
Explanation
Set the mode selection switch to PRGM mode.
The data for step 1 of the displayed bank and cam numbers
will be displayed.
Note If there is no data, the display will be “-- -- --.”
Press the P⋅CLR switch to clear all cam programs in the Cam
Positioner.
Note The P⋅CLR switch will be ignored by the system, even in PRGM mode, if the trial operation function is
being used. Trial operation cannot be performed in function level 1.
H Program Number Checking (SET Mode)
The number of steps in a new program are checked in SET mode.
D Program Number Checking Information
Function level
Function No.
1 to 8
(1 to 4)
(see note 2)
Note
Parameter No.
0 to 32
(1 to 16)
(see note 1)
Function
name
Program number checking
0
1
2
Display
The number of steps for the displayed bank and cam
numbers will be shown in the SPEED/ON display.
1. The numeric values for the 3F88L-160 (16-point model) Cam Positioner are shown in parentheses.
3-35