Download User Manual

NVR User Manual
Step 2: Click Setting button to go into live image.
Step 3: Press and drag the left mouse button to set mask area as shown below.
Step 4: Right click to exit the mask setting interface.
Step 5: Click Apply button to save the setting.
To delete mask area
Step 1: Click Setting button in the mask interface.
Step 2: Select a certain masked area and double click to delete that masked area.
Step 3: Then click Apply button to save the setting.
Fig 5-9 Setting Mask Area
5.3 Record Configuration
Record configuration includes five sub menus: enable, record bit rate, time, recycle record and
stamp.
Before Configuration, please make sure your NVR has been installed with HDD and has
completed its initialization.
5.3.1 Enable
Step 1: Enter into MenuSetupRecordEnable tab. Refer to Fig 5-10:
Step 2: Checkmark record and audio.
Fig 5-10 Record Configuration-Record
16