Download 2007 - Aries Spas

Aries Spas • User Manual
WARNING: Prolonged immersion in hot water may induce hyperthermia.
The causes, symptoms and effects of hyperthermia may be described as
follows: Hyperthermia occurs when the internal temperature of the body
reaches a level several degrees above the normal body temperature of
98.6˚F. The symptoms of hyperthermia include: drowsiness, lethargy and
an increase in the internal temperature of the body. The effects of hyperthermia include:
◊
Unawareness of impending hazard
◊
Failure to perceive heat
◊
Failure to recognize the need to exit the spa
◊
Physical inability to exit the spa
◊
Fetal damage in pregnant women
◊
Unconsciousness and danger of drowning
WARNING - The use of alcohol, drugs or medication can greatly increase
the risk of fatal hyperthermia.
Digital Temperature Readout / Adjustment Readout
The Spa-Side Control has a digital readout of the spa’s water temperature.
(It is not uncommon for the temperature shown to vary from the actual
water temperature by a few degrees.) This readout also displays the desired temperature as you reset (see below).
When your spa is initially powered up, or any time the power
has been lost, then restored, the temperature in the digital
readout will flash. Pressing any button on your Topside Control
will stop the flashing.
Up (Increase) and Down (Decrease) Arrows
To increase the water temperature, push and hold the “Up Arrow” button.
To decrease the temperature, push and hold the “Down Arrow” button.
As you hold the buttons to adjust, the digital temperature readout, which
previously showed the actual water temperature, will temporarily show
the “desired temperature” you are adjusting to. Once your desired temper-
Page 6