Download SH7410 E8000 Hitachi Debugging Interface HS7410D8IW2S User`s

5.2.18
GO_OPTION: GP
Description:
Sets emulation mode during user program execution.
Format:
Displays emulation mode during user program execution.
gp
Sets emulation mode during user program execution.
gp <eml_opt> | <ubcsq_opt> | <lvldisp_opt>
<eml_opt>
= eml_mode <eml_mode>
<ubcsq_opt>
= ubc_sq <ubc_sq>
<lvldisp_opt> = level_display <lvl_disp>
Table 5.19 GO_OPTION Command Parameters
Parameter
Type
Description
<eml_mode>
Keyword
Emulation mode. Refer to the next page for settings
(table 5.20).
<ubc_sq>
Keyword
Enables or disables a UBC sequential break. (Program
execution stops when the conditions set by
BREAK_CONDITION_UBC2 and 1 are satisfied in that
order.)
Set either of the following.
enable: Enables a UBC sequential break.
disable: Disables a UBC sequential break.
<lvl_disp>
Keyword
Enables or disables the display of the condition
satisfaction level of BREAK_CONDITION_SEQUENCE
and TRACE_CONDITION_SEQUENCE displayed in
the status bar.
Set either of the following.
enable: Enables display of the condition satisfaction
level.
disable: Disables display of the condition satisfaction
level.
Rev. 2.0, 09/00, page 251 of 298