Download D2nc User Manual
Transcript
Shape Description Language 98 J distance[,heading] [ ! | @ ] J Jump command distance Distance in working units to jump in the direction of the current heading. optional range -360 to [+]360 sets the heading relative to the current heading. optional line converter. Cause a line to be drawn to this point. Any sequence of jumps and warps will be converted into a cutting line from the last cut or anchor point. optional anchor this point. Excludes this jump being converted to construction line for a subsequent jump or to a cut on a subsequent jump or warp option 1. heading ! (option 1) @ (option 2) Usage Jump on the current heading for the specified distance. Jump is used to position the tool with G00 moves when translated to g-code. Example The jump 97 works as you would expect but has a few qualifiers and some behaviour that needs further explanation. The jump, when translated to g-code, equates to the tool making rapid moves above the cutting plane at the safe Z height as set in constraints 14 . In the shape display area the jump is represented by a red dashed line. A single jump with a heading change produces the following: j1,90 Consider a subsequent jump. Normally you should expect the tool to make a rapid move on the shortest possible path. To meet this expectation, when there are two or more jumps in a row, they are converted to construction lines (blue) and the resulting real jump or tool move calculated and shown in red. j1,90 j1 © 2005-2010 D2nc Software