Download D2nc User Manual

Transcript
Shape Description Language
98
J distance[,heading] [ ! | @ ]
J
Jump command
distance
Distance in working units to jump in the direction
of the current heading.
optional range -360 to [+]360 sets the heading
relative to the current heading.
optional line converter. Cause a line to be drawn
to this point. Any sequence of jumps and warps
will be converted into a cutting line from the last
cut or anchor point.
optional anchor this point. Excludes this jump
being converted to construction line for a
subsequent jump or to a cut on a subsequent
jump or warp option 1.
heading
! (option 1)
@ (option 2)
Usage
Jump on the current heading for the specified distance. Jump is used to position the tool with G00
moves when translated to g-code.
Example
The jump 97 works as you would expect but has a few qualifiers and some behaviour that needs
further explanation. The jump, when translated to g-code, equates to the tool making rapid moves
above the cutting plane at the safe Z height as set in constraints 14 . In the shape display area the
jump is represented by a red dashed line.
A single jump with a heading change produces the following:
j1,90
Consider a subsequent jump. Normally you should expect the tool to make a rapid move on the
shortest possible path. To meet this expectation, when there are two or more jumps in a row, they are
converted to construction lines (blue) and the resulting real jump or tool move calculated and shown in
red.
j1,90
j1
© 2005-2010 D2nc Software