Download Aberlink 3D Project X

Transcript
22.0 SHIFTING, ROTATING AND CANCELLING
REFERENCES
22.1 Applying Rotations or Shifts
It may be necessary during an inspection to apply a rotation or shift to the
inspected features. This can be achieved by using the Grid Shift button:
Clicking on this button will bring up the following window:
Now it is possible to apply a rotation or a translation to the measured features
by typing the required angle(s) or distance(s) into the relevant box(es).
For instance, consider a component that consists of a plate with holes in its
diagonal corners, which define a datum at 45 degrees. The best method for
inspecting the plate is to measure the position of the 2 holes, construct a line
between them and then set this line as a reference.
136
- -