Download Digital Security Controls

2.4 Global Wireless Device Placement Test
2.4 Global Wireless Device Placement Test
Wireless Device Placement
Perform the Wireless Device Placement testing on keypads, sounders and sensors only.
• This test is NOT required for wireless keys or pendants. Verify that pendants and Key FOBs operate within the desired
Operating area by arming and disarming the sytem.
• Test each device multiple times to ensure a good placement.
• If a device tests BAD reposition the device and retest. Slight changes in placement can cause significant differences in signal
strength and range of the wireless device.
Step
1
• To enter ‘Wireless Device Placement Test.
Press ,
represents the new installer code programmed in
Installer’s programming to replace the 5555 default installer code.
Step
2
Place the wireless device in the location where the device will be mounted.
Activate the device as described in the associated installation sheet.
T
F
A
• If the Alarm System receives a STRONG signal the bell will sound once and
‘Location is Good’ will be displayed on the LCD.
• If the Alarm System receives a WEAK signal the bell will sound 3 times and
‘Location is Bad’ will be displayed on the LCD.
• If the Alarm System indicates no response, reposition wireless device and repeat
test.
Step
3
i
R
D
Repeat Step 2 for Each Device.
When Placement is completed, press
to exit Installer’s Programming.
Enter Section
--Activate Device
For Test
Activate Device
Location is Good
Activate Device
Location is Bad
System is
Ready to Arm
<>
Two-way wireless keys must be activated by pressing any key before they become functional.
To re-enroll a wireless key press
simultaneously for approximately 2 minutes.
2.5 GPRS/Ethernet Module Setup/Initialization
i
Perform the following after system installation and programming.
Ensure that the following sections are programmed:
• Central Station Phone Number,(Template Programming - Entry 5)
(if applicable, in Sections [301]-[303] & [305])
• Account code, Sect [310], (Template Programming - Entry 6)
• Communications Format, Section [350]- Set to [04] SIA FSK
• GPRS/Ethernet Module Enable Sect [382] Opt[5] - Set to GPRS/Ehernet Module Enabled
2-7