Download Cue

Transcript
Installing remote video monitors
You may want to install additional monitors at remote locations. Install
monitors by connecting them to any interface devices on ETCNet. Additional monitors duplicate the master console’s displays in remote locations.
Connect monitors to interface devices by following these steps.
1. Insert the female end of the monitor power cord in the monitor connector, and the male end of the monitor power cord in the interface
device connector labeled Switched outlets.
2. Connect the cable to the connector labeled CRT 1 on the interface
device.
3. Turn monitor power switch to its On position.
VGA monitor console connector
HD-DB15 female
VGA monitor pinout
1
Red video
2
Green video
3
Blue video
4
Ground
5
Ground
6
Red ground
7
Green ground
8
Blue ground
9
not connected
10
Ground
11
Ground
12
not connected
13
H. (H/V) sync
14
V. sync
15
not connected
296
Impression 2 user manual