Download Paging - Spatch

displayed, use the UP/DOWN Arrow keys to position the bar over the desired choice, and press
RETURN to select it. If no choices are desired, press ESCAPE and enter a new key.
Protocol
This field will be set to the protocol defined in the Carrier Record linked to the pager. It will
almost always be TAP unless the TNPP or SMS protocol is used.
Coverage
If the TNPP protocol is selected, this field should contain the coverage designator for the pager.
The coverage designator selects a list of areas where the messages are to be sent.
Page Type
This field is valid only when using the TNPP protocol. It selects an ID or CAP page.
Max Msg Size Override
If this field is non-zero, it overrides the Max Msg Size field in the Carrier record. This feature
is only needed when the message size entered in the Carrier record is greater than that of
the pager.
Pager
The pager encoding method is defined in this field. It is used only with the TNPP protocol.
Function
This is the function code to be sent with the page when using the TNPP protocol. Its value will
depend on the pager used.
PIN/CAP
This is the Pager ID number (PIN) of the pager for alphanumeric messaging. Sometimes it is the
same number used to send a numeric page, sometimes it is not. Check with your paging carrier
to be sure. If you are using the TNPP protocol and the Page Type is CAP then this field should
contain the Cap Code of the pager.
If the type is DTMF, this field contains the pagers phone number. If a PIN must be entered after
the phone number, enter it after the phone number separated by 3 to 5 commas (the delay to
connect and bypass the prompt) (Ex. 3215049,,,123).
Delay
This field is only used for DTMF pages. It is the number of 2 second increments to wait before
sending the numeric message after the phone number is dialed. Enough time must be allowed to
connect and skip over the prompt.
STORE
Press RETURN on this action button to store the information entered in the database.
DELETE
Press RETURN on this action button instead of STORE to delete the record.
25