Download Macro Station Users Manual

Transcript
UMAC MACRO and MACRO Stack User Manual
•
•
•
•
Station node-specific variables MI910 - MI939 configure hardware for the machine
interface channels associated with specified MACRO node by SW1
For stack axis-interface boards, appropriate ACC-8x breakout boards or equivalent for
Station JMACH connectors provide easy wiring interface to external devices.
For UMAC (“pack”) axis-interface boards, breakout connectors are integral to the boards.
Wiring between breakout connectors and external devices provides physical connection.
2. Mapping the 3U MACRO Station’s machine interface channels to the Station’s MACRO
motor node registers:
•
•
•
Station SW1 switch setting controls mapping of output commands and flags between
machine interface channels and nodes
Station Encoder conversion table (MI120-MI151) and Motor x variables MI10x control
mapping of feedback position from machine interface channels to Station MACRO nodes
Station Motor x variables MI11x control mapping of power-on absolute feedback
position to Station MACRO nodes
Mapping Machine Interface Channels to MACRO Nodes
Machine Interface
Channel x Registers
Output A DAC, PWM
Node n / Channel x mapping is
determined by station SW1 setting
MACRO
IN
0
1
2
Output B
DAC, PWM
Output C
PFM, PWM
Control
AMP Enable
3
Command
Registers
3
Feedback
Registers
PMAC Node n Registers
MACRO
OUT
0
1
2
Status
Flags
ADC B
Current Feedback
Signals
ADC A
MI10x
Station Encoder
Conversion Table
MI120 - MI151
Encoder
Position Feedback
Signals
3. Mapping the 3U MACRO Station’s MACRO motor node registers to the PMAC2’s [Turbo
PMAC2’s] MACRO motor node registers
•
•
•
•
•
4
Connection of the PMAC2 and MACRO Station in a common ring
PMAC2 MACRO cycle frequency control
PMAC2 Ultralite I992 and I997 [Turbo:I6800, I6801]
PMAC2 (non-Ultralite) I900 and I901 [Turbo I7000, I7001, or I7200, I7201]
PMAC2 I995 MACRO Master Type [Turbo: I6840, I6890, I6940, I6990]
3U MACRO Station Setup Overview